3 Stücke Ersatz fernbedienungen für den besten Preis!!! These remote control replacements are compatible with Hörmann RSC2-433 433,92Mhz remote control. Compatible with the following EcoStar garage door operator models: Ecostar Liftronic 500, 700, 800 and Portronic D5000, S4000, D250 Programming / Learning Instructions 1. Press the LEARN button or the transparent button located under the ECOSTAR motor. The LED light on the motor blinks slowly. Let the button go. 2. During the next 10 seconds, press a desired button on your new remote control. 3. The LED light on the motor blinks faster. Let the button go. 4. Press the same button again on your new remote control. Keep it pressed down. 5. The LED light on the motor blinks very fast. Let the button go. 6. Your new remote control is programmed. ATTENTION : You can program only 6 RSE2 remote controls with the ECOSTAR motor To erase all your remote controls: 1. Press the transparent button P located under the ECOSTAR motor. Keep it pressed down. 2. Wait 5 seconds. Let the button go. 3. The LED light on the receiver blinks slowly for 1 second, then faster for 4 seconds and then very fast for 2 seconds. 4. All the remote controls are erased. Anleitung: 1. Drücken Sie kurz auf die Taste am Empfänger. Die Lampe blinkt langsam. Dann haben Sie 10 Sekunden Zeit den Handsender anzulernen. 2. Drücken Sie eine Taste am Handsender, die LED am Antrieb blinkt schneller. Nun drücken Sie die gleiche Taste am Handsender nochmal. Die LED blinkt noch schneller. 3. Der Handsender ist nun an Ihrem Antrieb programmiert und kann verwendet werden! If you want to increase the remote control reception range up to 150-200 meters, then you can connect this aerial: https://www.amazon.de/dp/B01MTOYB0F . IF YOU HAVE ANY QUESTIONS ABOUT YOUR PURCHASE PLEASE CONTACT US!